Custom Boat Rod Holders.

$44.95
 

please specify pipe size

1. Aluminum Pipe: 3/4 inch OD, 2 5/8 inch cir 2. Aluminum Pipe: 1 inch OD, 3 1/4 inch cir 3. Aluminum Pipe: 1 1/4 inch OD, 4 1/8 inch cir 4. Aluminum Pipe: 1 1/2 inch OD, 5 1/4 inch cir 5. Aluminum Pipe: 1 3/4 inch OD, 6 inch cir 6. Aluminum Pipe: 2 1/4 inch OD, 7 1/2 cir 7. Stainless Pipe: 7/8 inch OD, 2 1/4 inch cir 8. Stainless Pipe: 1 inch OD, 3 1/8 inch cir 9. Stainless Pipe: 1 1/4 inch OD, 4 inch cir 10 Aluminum Pipe: 2 inch OD, 6 1/4 inch cir. (Stryker T-Top)

Please choose color

White Black

 Our custom rod holder is a clamp-on straight shot vertical mount rod holder consisting of 2 clamp-on holders and a rod holder insert. The holders, excluding rod holder sleeve, are made of high quality UV protected marine grade starboard and the rod holder insert is tough and durable plastic sleeve. All this and no moving parts makes these rod holders extremely durable and long lasting.
They install in minutes without drilling any holes in your boat, are adjustable after installation, and will rotate around pipe without damaging the pipe beneath. The rod holder sleeve is an extremely tight fit, but can also be rotated within holder to any position. The rod holder sleeve has tuliped lip and a cutout for spinning reels. Mount to casting and polling platforms or any upright vertical pipe. Mounting hardware included. 
They can withstand a lot of bouncing, bucking, and pounding and still will not move up and down on the pipe they are mounted on.
 Each holder is a precise custom fit for each aluminum or stainless pipe size variation.
Click here for printable ruler.
Included with your custom holder is the rod holder sleeve, 4 stainless steel allen screws, and the allen wrench for installation.
You can use calipers or a tape measure to get the outside diameter (OD), use a flexible tailors ruler to measure your pipes circumference, or you can print out our custom ruler and wrap it around the pipe you will be mounting your drink holder on.  
Dimensions:
Rod holder sleeve is 11 1/2 inches tall.
You need 1 inch clearance for the back C half of holder for those tight spaces
Pipe size chart.

Shipping Notice: Because all of our marine drink holders are custom made, normally your order will ship within 48 hours.
However on rare occasion some products may take 3-4 days before orders are shipped. Thank you for understanding.
Please double check your measurements for your clamp-on drink holders. We want to be sure you order the correct size for a nice snug fit. We don't want y'all to have to pay all that extra shipping to get it to us and back to you again, or if you don't know the size you can order our 
new universal clamp-on mount drink holders, a single holder will fit a wide range of pipe sizes. 
Please print the ruler or call us if you need assistance, (855) 777-CUDA.
Thank you. Tight Lines!!!

All Holders are Invented, Custom Made, and Manufactured, by us Cuda's Customs, Right Here in the USA.

 Follow @CudasCustoms